bandeau Fischer

Orientation of mounting flats to guide sleeve position
 
Types of Panel Cut-Outs


 Connectors with standard code 1
Connectors are here seen from the front side which is the mating face. The orientations of the contact blocks to the arc-shaped guides are shown in section P of our general catalogue, but always from the wiring side. The following rules are only valid for standard versions. Other orientations of guides and/or guide marks may exist as special options.
 Fixed Connectors for cut-out according to Type 2
All connector types “A” and “Z” for D-hole mounting per Type 2 have the arc-shaped guide on the left side when the mounting flat is in the 12 o’clock position. A standard connector mounted in this hole will have its guide mark at the 12 o’clock position.
 Fixed Connectors for cut-out according to Type 3
All connector types “A” and “Z” for double D-hole mounting per Type 3 have the arc-shaped guide oriented in parallel to the two flats. A standard connector mounted in its hole will have its guide mark at the 12 o’clock position when the arc-shaped guide is placed to the left side of the connectors.
 Connectors with special code 2
See “Connector Keying and Orientation” on page L4 of our general catalogue, and refer to drawings of these special connectors.

Our new Headquarters


Technical information


Job
Français |

English

| Deutsch |  Italiano
Job | Connect | Search |Site map | Legal
Last revised : 01.12.2008 / Webmaster